QSc K12 and Ksub

Moderators: Cameron Shoffner, Christian Cook, Kirk Fyvie, Martin Barbour, Gary Evans_QSC

Sat Nov 07, 2015 5:27 am

  • Could you advise of correct way to connect 1 Ksub with 2 K12 speakers please?
    Would it be Left and Right channel mixer out to Line in A and Line in B on Ksub, then connect to each K12?
    And would you set both K12 switches to EXT Sub?
    Possibly an old pro
    Posts: 34
    Joined: Thu Oct 20, 2005 1:01 am
    Location: uk

Mon Nov 09, 2015 3:34 pm

  • Yes, you can route the signal cables that way.

    Typically, you would set the K12 loudspeakers to EXT SUB so there will not be overlap between them and the sub. This would allow greater headroom in the K12s.

    But you can also experiment with using FULL RANGE if you wish and see if you like that sound better. Just be aware that it will probably cut into the available headroom.
    Bob Lee
    Technical Communications Developer
    QSC, LLC
    Fellow, Audio Engineering Society
    "If it sounds good, it is good." —Duke Ellington
    User avatar
    Bob Lee
    QSC Audio Products
    Posts: 2518
    Joined: Thu Mar 06, 2003 2:01 am
    Location: Costa Mesa, California

Return to Loudspeaker Support

  • Users browsing this forum: No registered users and 1 guest